Step by step instructions:
1 Measure the length of the kitchen through the window card base. In our case it was 89.5 inches.
2 Understanding the length of the new upstairs bar. Standard lengths of prefabricated counters are four feet, two feet, two feet and three feet. Select the length that is more than the size of next mouth. In our case it was three meters.
3 Decide how deep you want to be your top bar. This is a matter of personal taste, but you need ahis little "piece" later as a conservative. We chose 23-inch, 5 inches on top of the window ledge base and 18 cm. Adjust the circular saw blade 1 / 8 "deep, the thickness of the worktop. Back Measure from the bull-nose side of the bar to the desired depth and mark both ends. Run a length of narrow ribbon from side to side ' another brand. and the other will take over the tape for good or held together in a perfect line, this has two functions. First, they give you a baseline forcut, and secondly to avoid that the laminate from chipping. Cut to follow the entire length of the work plan and look at the band edge in a perfect line. Keep your hand still, the smallest splash.
4 grooves are cut into the top bar so that the cut or the window of the base side is the right length. Bars are symmetrical peaks, but you can enter the notches as long as the window frame that the base is the right length to fit. If you start with the notchesSaw you must remember to stop, behind the cutting notch, and completely finished with a hand saw. It 'better to do only the total score with a hand saw. Cut notches on both sides to a depth in the same window as the base. We had 5 inches.
Step 5 and install the brackets with screws and drill. Install the pin layout for the wall for the best.
6 Lift block the new upstairs bar. Check for a good fit. Remove and cut by hand saw, ifare needed. Run a bead of adhesive directly to the liberal base of the window and replace the top bar, press on the glue. Check whether it's back end and front-to-end at different points along their length.
7 Tighten the bar at the top of the brackets with screws that are too long and penetrate into the top bar.
8 Follow the instructions on the kit order. Cut the tails correspond to the new depth and iron with a hot iron. Keep moving the iron when in contact with theMaterial, so as not to burn.
9 Then the circular saw is one-eighth inch deep. Run two straight parallel cuts, one inch apart from scrap on the backsplash of the work plan. Remove the laminate with a hammer and a flat-blade screwdriver not to break or divide the strip of laminate. With this band to hide the cut the top of the new bar. Cut the strips to length and glue the cut edge. Use tape to keep him around until the glue dries.
10 Make asmall amount of silicone around all edges of the top bar. Smooth the caulk with a wet fingertip joint. Sand the edge with 150 sandpaper to remove any sharp points.
Enjoy your new granite tops are really looking for!
0 comments:
Post a Comment